Get free shipping on qualified Carbon Monoxide Detectors products or Buy Online Pick Up in Store today in the Electrical Department.
Near or in furnace and water heater closets. Do not place carbon monoxide alarms in gas-fired furnace or water heater closets. This will help reduce nuisance tripping and when some of these appliances startup they will often burp a minor amount of CO that may trip the alarm. Secondly, many manufactures recommend that an alarm be 15 feet, plus
Immediately evacuate the building to fresh air and safety. Call 9-1-1 once safely outside to report the incident and if there is anyone experiencing carbon monoxide poisoning symptoms like headaches, dizziness and vomiting. Do not return into the building until it has been cleared by first responders. Even if your alarm stops alerting, and you In Alarm: the detector is silenced for 5 minutes. It will sound again after 5 minutes if the carbon monoxide is still detected. NOTE: if high levels of CO are present (>350ppm), the detector cannot be silenced. If the CO detector goes off, leave the house immediately. Low Battery: the detector chirping is silenced for 12 hours.
4. Detector placement: Proper placement of the carbon monoxide detector is crucial for optimal performance. Detectors should be installed at a height of around 5 feet from the ground, as carbon monoxide tends to mix with air at that level. They should also be placed near bedrooms and common living areas for early detection.
Yes. You can replace a smoke detector with a combination smoke/CO unit. All modern First Alert and BRK alarms use the same wire harness and connector. If the alarms in your home are interconnected with 120V AC interconnection, keep in mind that only CO and combination detectors will alarm in the event of a high CO condition.
. 676338760534222870379317
